- Home
- Mobile
- Design Management
- Irrigation Calculators
- Sprinkler
- Center Pivot
- Chemigation
- General
- Field Area
- Fitting Pressure Loss
- Irrigatable Area
- Irrigation Frequency
- Irrigation Run Time
- NPSHA
- Pipe Size Estimate
- Pipe Velocity and Diameter
- Pipeline Pressure Loss
- Pipeline Pressure Rating
- Pressure Loss with Outlets
- Required Maximum Flow Rate
- Required Water Pump Horsepower
- Set Times
- System Capacity
- Total Dynamic Head
- Water Application Rate
- Water Depth
- Water Hammer
- Water Supply Design
- Water Measurements
- FAQs & Tutorials
- Irrigation Resources
- Washington Irrigation
- Idaho Irrigation
- Oregon Irrigation
- Irrigation Links
- About
- Contact Us
Estimating a Single Sprinkler Discharge
This calculator estimates the water application for a single sprinkler by setting up a simple home experiment. In order to replicate the experiment, you will need two sprinklers of the same type, and 4 cans.
Arrange the four cans between two sprinklers as shown in the figure below. Operate the sprinkler for 15 minutes or more and measure the depth of water collected in each can. Enter the measured depths in the following boxes.
Learn more about the units used on this page.
Sprinkler Flow Rate